How to install Xiaomi Air purifier Mod Chip to your 2S 3H Pro device.

Step 1:
Remove the power cord and wait until the device is fully powered off.
Failing of this step has a high risk of electric shock or damaging the air purifier.

Step 2:
Turn the device upside down.

Step3:
Remove the four rubber feet. (I used a flat screwdriver to wiggle them out)

Step 3.5:
Remove the four Phillips screws underneath the rubber feet.

Locations of the rubber feet. (under there are Phillips screws)

Step 4:
Remove the Black cover (hold the edges near the rubber feat and wiggle)

Cover removed,

Step 5:
DO NOT TOUCH THE MIDDLE PART!! IT WILL HURT AF OR YOU CAN DIE!!! (Even with the power cord not in the device, some large capacitors can still hold an electric charge)
Ps. I’ve tried it. Burned two small holes in my fingers and hurt for days…..

Step6:
Read the warning again.
Now remove the four screws highlighted in the image above. Lo and behold: The Xiaomi NFC PCBA

Xiaomi NFC PCBA

Step 7:
Remove the two screws, and replace the XIAOMI NFC PCBA for the MODCHIP.

Final result should look like this:

Xiaomi Air Purifier with modchip installed.

Step 8:
Do all the steps backwards starting with step 6

Step 9 :
Party! you’ve done it! Congrats 🙂

I sell on Tindie

7 comments

  1. Hi Dude thanks for the Modjo works like Charm.My question might be of xiaomi get the hack by Update their soft is this the End of the modjo of Will you make Further updates?

Leave a Reply to admin Cancel reply

Your email address will not be published. Required fields are marked *